一、電芯老化設備簡介：

1.1 設備功能和原理介紹：設備采用熱風強制對流加熱的方式，每個腔體控制系統(tǒng)相對獨立，以滿足不同時間出入爐需求；每套加熱控制系統(tǒng)采用雙重電子式溫控器控制，以保證控溫精度及可靠的異常超溫保護需求。

1.3   電芯老化總體結構

整機外型尺寸: (大約)長：5050mm；深：2000mm；高：2400mm。

    工作室有效內尺寸： 深：1900mm；寬：1000mm；高：1800mm

A, equipment introduction:

1.1 equipment function and the principle is introduced: with the method of hot air forced convection heating, each cavity is relatively independent control system, in order to satisfy the demands of different time of charging; Each heating control system adopts double electronic thermostat control, to ensure that the temperature control precision and reliable abnormal overtemperature protection requirements.

1.3 overall structure

The machine installation dimensions: (approximately) length: 5050 mm; Deep: 2000 mm; Height: 2400 mm.

Studio in the effective size: deep: 1900 mm; Width: 1000 mm; Height: 1800 mm

Second, the equipment can adapt to the processing and product specifications

2.1 per room can be placed two stａnd for a car, at the same time let stａnd for car size: 670 mm wide; 820 mm long; 1660 mm high.

Third, equipment technical parameters

3.1 equipment 40-80 ℃ temperature range.

3.2 equipment temperature control precision is + / - 5 ℃.

3.3 equipment failure rate of 1% or less (caused by equipment failure)

3.4 equipment of furnace chamber under no-load condition from room temperature up to + 80 ℃ is less than 30 minutes.

3.5 equipment within the cavity size: 1000 * 1800 * 1900 (width * * deep).

3.6 electrical equipment: three-phase voltage 380 v, current 120 a, 30 kw power.

3.7 compressed air: 6-8 KGF/cm

3.8 wind pressure and flow rate of 716 pa / 4110 m2 / h

3.9 weight: total weight 580 kg total weight and the ratio of the load bearing area of 500 kg/M2 or less

二、設備能適應的來料和產品規(guī)格

2.1每間房可同時放置2個靜置車，靜置車尺寸：寬670mm；長820mm；高1660mm。

三、電芯老化設備技術參數

3.1 設備的恒溫范圍40-80℃。

3.2 設備的溫度控制精度±5℃。

3.3 設備故障率≤1%（指由設備造成的故障）

3.4 設備的爐腔空載狀態(tài)下從室溫升到+80℃小于30分鐘。

3.5 設備的內腔尺寸：1000*1800*1900（寬*高*深）。

3.6 設備電氣：電壓三相380V，電流120A， 功率30KW。

3.7 壓縮空氣 ： 6-8kgf/cm

3.8 風壓和流量 716pa/4110m²/h

3.9 重量：總重580Kg  總重與承重面積之比≤500kg/M²